HowTo apply adhesive vinyl wall decals...Wall art provided by designwithvinyl.com Step 1. Preparing the graphic Remove your graphic from the box and lay it face up (so that the lettering is readable in this position) on a clean, dry, flat surface. Using the a application tool, rub the graphic as illustrated in the figure at right, working from the middle to the outside edge. This will remove any wrinkles and ensure that the graphic is securely attached to the transfer tape. Step 2. Preparing the wall surface Prepare your wall for installation ensuring that it is free of dirt, wax, oils and moisture. Make sure walls are completely dry before applying your graphic. Step 3. Placing the graphic Your eye will judge you're graphic as being level by comparing it to the closest parallel line. This could be the top of a door jam or tabletop or perhaps the line where the wall meets the ceiling. Therefore, you should measure each end of the graphic to that parallel line so that it will be level to the eye. Center the graphic horizontally by making sure that each end is an equal distance from the ends of the space where it is to be placed. Then re-check to make sure the you're graphic is still parallel to the closest parallel line mentioned above. See the figure at right. It illustrates putting a small piece of tape at each end of the graphic so that each is held in place as you adjust the other end. Step 4. Hinging the graphic Once the graphic is level, run a continuous line of ...
Keywords: how to
No comments:
Post a Comment